甲烷毛細管柱：

固定相：多孔層開口管分子篩柱或其他等效毛細管柱

規格：30m*0.53mm*25um

應用：HJ 38-2017 固定污染源廢氣 總烴、甲烷和非甲烷總烴的測定 氣相色譜法

本標準規定了測定固定污染源廢氣中總烴、甲烷和非甲烷總烴的氣相色譜法。

      本標準適用于固定污染源有組織排放廢氣中的總烴、甲烷和非甲烷總烴的測定。

當進樣體積為1.0 ml時，本方法測定總烴、甲烷的檢出限均為0.06 mg/m³（以甲烷計）,測定下限均為0.24 mg/m³（以甲烷計）；非甲烷總烴的檢出限為0.07mg/m³（以碳計），測定下限為0.28mg/m³（以碳計）。

HJ 38-2017 固定污染源廢氣 甲烷的測定  測試譜圖：

HJ 38-2017 Stationary pollution source waste gas - Determination of methane
HJ 38-2017 Determination of Methane in Waste Gas from Stationary Pollution Sources Details:

Methane capillary column:

Stationary phase: Porous layer open tube molecular sieve column or other equivalent capillary column

Specifications: 30m*0.53mm*25um

Application: HJ 38-2017 Waste gas from stationary pollution sources-Determination of total hydrocarbons, methane and non-methane total hydrocarbons-Gas chromatography



This standard specifies the gas chromatography method for the determination of total hydrocarbons, methane and non-methane total hydrocarbons in waste gas from stationary pollution sources.

       This standard is applicable to the determination of total hydrocarbons, methane and non-methane total hydrocarbons in the waste gas of fixed pollution sources.

When the injection volume is 1.0 ml, the detection limit of this method for the determination of total hydrocarbons and methane is 0.06 mg/m3 (calculated as methane), and the lower detection limit is 0.24 mg/m3 (calculated as methane); non-methane total hydrocarbons The detection limit is 0.07mg/m3 (calculated by carbon), and the lower limit of determination is 0.28mg/m3 (calculated by carbon).

HJ 38-2017 Determination of Methane in Exhaust Gas from Stationary Pollution Sources Test Spectrum: